How do you reset the SRS light on a Mitsubishi?

How to reset airbag light on a Mitsubishi

Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side.
Turn on the ignition and allow the scanner to power on.
Select your Mitsubishi model and year.
Select SRS / Airbag Control unit from the main menu.
Select Read Fault Codes.

How do you reset the SRS?

Reset Your SRS Light

There is a yellow plug under the dash plugged into the fuse panel.
Turn the ignition key to the “ON” (II) position.
When the SRS light comes back on plug the jumper wire back in within 4 seconds the light will blink twice and go out.
Unplug the jumper and turn the ignition key off.

How do you fix a SRS airbag fault?

How to Reset an Airbag Light

Put the key into the ignition and turn the switch to the “on” position.
Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
Repeat Steps 1 and 2 two more times.

How do you reset the SRS light on a Mitsubishi l200?

Put the key into the ignition and turn it to the “Acc” position, but don’t allow the engine to turn over. Plug the OBD-II scanner into the diagnostic port under the steering column. Wait for the scanner to read the codes and then press “Clear trouble codes” or “Reset” or some similar command to reset the airbag light.

Why does my SRS light stay on?

If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.

What happens if you disconnect the airbag light?

You may have made the mistake of turning on the key while installing your car radio without plugging in car airbag components. Doing this will cause your airbag light to flash, and it can be distracting if you leave it on as it is. Turning off the airbag light yourself can save you a trip to your car dealer.

Why does the Mitsubishi SRS warning light stay on?

Mitsubishi airbag warning light stays on to notify the driver that the airbags may not deploy if you get in an accident. Airbag or SRS light stays on when the Supplement Restraint System (SRS) detects a malfunction. If the airbags don’t deploy during an accident, you or your passengers may suffer serious injuries.

When does the SRS airbag warning light come on?

Low voltage – SRS airbag light can be triggered when you jump-start a dead car battery. Previous accident – Even a small accident may be recorded in the SRS module triggering the airbag light to come on.

How can I reset the airbag light on my Mitsubishi?

You can reset the airbag light on your Mitsubishi right from your home garage or driveway, saving yourself time and money. The airbag light will illuminate on the instrument panel as “SRS,” which stands for “Supplemental Restraint System.”. Usually this light only turns on when the vehicle has been in an accident.

Is the Mitsubishi SRS airbag module affected by Takata?

You may need to have a specialist reset the Mitsubishi SRS module, which you can easily do by ordering this service on eBay. Mitsubishi vehicles were impacted by the Takata airbag problems that affected many manufacturers. One way to find out is to call your local Mitsubishi dealer and check if your vehicle is affected.

How do you reset the SRS light on a Mitsubishi? How to reset airbag light on a Mitsubishi Plug the Mitsubishi airbag scanner into the OBD2 port under the dashboard, driver’s side. Turn on the ignition and allow the scanner to power on. Select your Mitsubishi model and year. Select SRS / Airbag Control unit…