How far does the PetSafe collar go?

This layout provides a larger pet area around the perimeter of the house than a single transmitter. The maximum range is at least 90 ft. on any of the PetSafe® Wireless Fence systems.

How do I increase the intensity of my PetSafe collar?

With the Receiver Collar turned on, press and release the Mode Button briefly. When released, the unit will flash indicating the Correction Level by the number of times the indicator flashes. Press the mode button again within 5 seconds of the last red flash and it will increase one level.

Can I add a collar to my PetSafe system?

Yes. There is no limit to the number of pets you can contain with the containment system. It’s as simple as purchasing an additional compatible receiver collar for each pet. You can purchase additional receiver collars online or contact our Customer Care Center.

What does ABC mean on petsafe?

There is a switch on the side of your transmitter, it may read “A,B,C” or “High, Low”. The settings on the A, B, C switch help to adjust the resistance in your containment perimeter.

How do you reset a petsafe collar?

How do I re-synchronize my wireless system?

Remove the receiver collar from your pet.
Remove the battery from the receiver collar.
At the transmitter, move the boundary switch from the low to the high position.
Slowly adjust the boundary control dial up to #8, down to #1 and then back to the #4 position.

How do I know if my PetSafe collar is working?

Take the receiver collar, use the test light tool or listening to the collar for the beeping. As you walk away from the transmitter and approach the boundary, the test light illuminates or you’ll hear the collar beep at the boundary. If this happens, the system is working.

How long do Invisible Fence collars last?

If your pet’s collar correction level is set too high, this could lead to your pet becoming afraid of your yard and contribute to bad behaviors. How long does the Invisible Fence wire last? Invisible Fence boundary wire is a direct burial grade wire and has a life expectancy of 27 years left undisturbed in the ground.

How do I test my PetSafe collar?

All you have to do is hold the tool against the contact points on your dog or cat’s receiver collar to check if the collar is working properly. The test light tool will light up if static correction is being activated.

Why does my PetSafe collar not work?

Take battery out of the collar for several minutes and replace it with new battery. Make sure battery is installed properly. Make sure the tab within the battery housing unit is making good contact. If receiver collar still does not activate – remove a wire from the transmitter, try to change the levels.

Where do you put the PetSafe stubborn dog collar?

Make sure that the battery is not installed in the Receiver Collar. 2. Start with your pet standing comfortably (2A). 3. Place the Receiver Collar on your pet so that the “PetSafe®” logo is facing your pet’s chin. Center the Contact Points underneath your pet’s neck, touching the skin. Note: It is

Where do you place the receiver collar on a dog?

Place the Receiver Collar on your pet so that the “PetSafe®” logo is facing your pet’s chin. Center the Contact Points underneath your pet’s neck, touching the skin. Note: It is sometimes necessary to trim the hair around the Contact Points to make sure that contact is consistent.

What is short loop test for dog collar?

The Short Loop Test is a simple test to determine if each component (Fence Transmitter, Receiver Collar and Boundary Wire) is functioning properly. Disconnect the Boundary Wire. Cut approximately 10 feet of unused Boundary Wire and connect it to the Boundary Wire Terminals.

https://www.youtube.com/watch?v=s6w6pIrKUP0

How far does the PetSafe collar go? This layout provides a larger pet area around the perimeter of the house than a single transmitter. The maximum range is at least 90 ft. on any of the PetSafe® Wireless Fence systems. How do I increase the intensity of my PetSafe collar? With the Receiver Collar turned…